The installation procedure for the motorcycle throttle cable is as follows:
1. Thread the throttle cable through the carburetor's top cap and slide the spring onto the cable. Next, pass the cable through the throttle valve opening, pull it through the side slot, and route it to the bottom; finally, seat the cable end into the recess at the base of the throttle valve.
2. When inserting the throttle valve into the carburetor, ensure the side with the small bevel faces the idle speed screw and the long vertical groove aligns with the raised tab inside the carburetor body; slide it all the way down and then securely tighten the cap.
Both cables lead to the throttle grip on the right handlebar. The upper cable is the throttle cable, which controls the throttle valve and jet needle. The adjacent cable is the accelerator pump cable; when the throttle is twisted rapidly, it triggers the carburetor to spray a jet of fuel into the venturi, thereby improving acceleration during quick bursts of speed.
